You issue the following commands on SwitchA:
feature vpc vpc domain 101 peer-keepalive destination 192.168.1.2 source 192.168.1.1 vrf mgmt interface port-channel 1 switchport mode trunk vpc peer-link interface port-channel 3 switchport mode trunk vpc 3
You issue the following commands on SwitchB: feature vpc vpc domain 101 peer-keepalive destination 192.168.1.1 source 192.168.1.2 vrf mgmt interface port-channel 1 switchport mode trunk vpc peer-link interface port-channel 3 switchport mode trunk vpc 3
Which of the following is true?
- The switch port mode is not correctly configured for port-channel 3.
- The switch port mode is not correctly configured for port-channel 1.
- The switches will successfully form vPC domain 101.
- SCR The vPC number in port-channel 3 is not correctly configured.
- The peer keepalive configuration is in the wrong VRF instance.
In this scenario, the switches will successfully form virtual port channel (Vpc) domain 101. A vPC enables you to bundle ports from two switches into a single Open Systems Interconnection (OSI) Layer 2 port channel. Similar to a normal port channel, a vPC bundles multiple switch ports into a single high-speed trunk port. A single vPC domain cannot contain ports from more than two switches. For ports on two switches to successfully form a vPC domain, all the following must be true:
– The vPC feature must be enabled on both switches.
– The vPC domain ID must be the same on both switches.
– The peer keepalive link must be configured and must be 10 gigabits per second (Gbps) or more.
– The vPC number must be the same on both switches.
In this scenario, the feature vpn command has been issued on both SwitchA and SwitchB. This command ensures that the vPC feature is enabled on each switch. In addition, the vpc domain 101 command has been issued on both switches. This command ensures that each switch is configured to operate in the same vPC domain.
The switch port modes are correct for port-channel 1 and port-channel 3 in this scenario. Port-channel 1 on SwitchA and SwitchB is configured as a trunk port. In addition, this port channel is configured with the peer keepalive link for this vPC domain. The peer keepalive link requires a trunk port. Port-channel 3 is also configured as a trunk port. Normal port channels can be configured as either access ports or trunk ports. However, you should configure normal port channels as trunk ports if you intend to have traffic from multiple virtual local area networks (VLANs) traverse the port.
The vPC number is correctly configured in this scenario. In order to correctly form a vPC domain between two switches, the vPC number must be the same on each switch. In this scenario, a vPC number of 3 has been configured on port-channel 3 on each switch. Port-channel 3 is a normal trunk port channel.
The peer keepalive link is not in the wrong virtual routing and forwarding (VRF) instance in this scenario. Peer keepalive links can be configured to operate in any VRF, including the management VRF. The peer keepalive link operates at Layer 3 of the OSI networking model; it is used to ensure that vPC switches are capable of determining whether a vPC domain peer has failed. On SwitchA, the peer-keepalive command has been issued with a source Internet Protocol (IP) address of 192.168.1.1 and a destination IP address of 192.168.1.2. On SwitchB, the peer-keepalive command has been issued with a source IP address of 192.168.1.2 and a destination IP address of 192.168.1.1. Based on this information, you can conclude that SwitchA is configured with an IP address of 192.168.1.1 and that SwitchB is configured with an IP address of 192.168.1.2.